Advertisement
Read these Safety Instructions before using the switch for the first time and follow the Operating instructions.
Safety instructions
1.
The installation, initial operation and maintenance should only be carried out by a qualified expert with electrical know-how.
2.
Comply with the local and statutory rules and/or the VDE0100.
3.
Before electrical connection, check the specifications on the data plate and the technical data of this manual.
4.
A fuse must be connected in series to the supply voltage, according to the Standard and Normative documents.
5.
Protect the signal contacts of the limit switch against voltage peaks when inductive or capacitive loads are connected.
6.
The device may be put into operation only if the electrical connection is correct. To secure the type of protection, the sealing cap and the gasket
must be placed correctly.
7.
The earth connection of the device has to be installed in such a way that mechanical damage will be excluded.
8.
For a proper function, the paddle must not touch the pipe
9.
For a proper function, the device must be installed in straigh pipes with a mininum length at least of five times the diameter and far from valves or
filters to avoid turbulence.
10. Switch off the power supply, before disconnecting the device.
10/15 © by FILSA MI-LIT2LITV-EN-02
02
Talleres Filsa, S.A.U.
•
E-08100 Mollet del Vallès (Barcelona) Tel. +34 93 570 46 01 Fax +34 93 570 24 71 filsa@filsa.es
LIT-2, LIT-VL, LIT-VP, LIT-VT and LIT-VTM
and it is necessary to ensure the free movement of the paddle.
•
•
•
•
www.filsa.es
Advertisement
