Advertisement
Available languages
Available languages
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the
following measures:
. Reorient or relocate the receiving antenna.
. Increase the separation between the equipment and receiver.
. Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
. Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, any changes or modifications not
expressly approved by the party responsible for compliance could void the user's
authority to operate this equipment. (Example - use only shielded interface cables
when connecting to computer or peripheral devices).
Radiation Exposure Statement
This equipment complies with FCC RF and IC RSS-102 radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 0.5 (for FCC) / 1 (for IC) centimeters between the radiator and your
body. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter. The antennas used for this transmitter must be installed to provide
a separation distance of at least 0.5 (for FCC) / 1 (for IC) cm from all persons and must
not be co-located or operating in conjunction with any other antenna or transmitter.
Cet équipement est conforme aux CNR-102 d'Industrie Canada. Cet équipement doit être
installé et utilisé avec une distance minimale de 1 centimètres entre le radiateur et votre
corps. Cet émetteur ne doit pas être co-localisées ou opérant en conjonction avec autre
antenne ou émetteur. Les antennes utilisées pour cet émetteur doivent être installés et
fournir une distance de séparation d'au moins 1 centimètre de toute personne et doit pas
être co-située ni fonctionner en conjonction avec une autre antenne ou émetteur.
This device complies with Part 15 of the FCC Rules and with RSS-247 of the Industry
Canada Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
Advertisement
