Delta Light 300 90 009 Installation Instruction

38 mm
38 mm
Warning!
Only qualified professionals should make
!
Beschermd tegen vaste voorwerpen die groter zijn dan 12 mm
Protégé contre les objets solides de plus de 12 mm
Geschützt gegen Festkörper größer als 12 mm
Protected against solid objects greater than 12 mm
Protegido contra objetos sólidos superiores a 12 mm
Protetto contro oggetti solidi più grandi di 12 mm
Description
This interface is designed to connect any 'normal open' push
button to a casambi network. Powered by a battery the
interface doesn't need more cabling then the wires between
the interface and the push buttons. 1 to 4 push buttons can be
used and they can be con gured in the app to control a lamp, a
group of lamps, a scene/animation or just control all lamps in
one press.
The box is small enough to fit any wall box and the wires are
a size that will fit any screw terminal. The interface is compa-
tible with all products that are compatible with the casambi
bluetooth network.
Each time a button is pressed the module will be activated for
a few seconds and then goes automatically in a standby mode.
This in order to preserve the battery capacity. Battery status
can be checked in the app onthe 'switches' screen.
To ensure a long battery life this interface will not be active in
the bluetooth mesh the whole time. You can't use this as a
mesh repeater'
Ref: 300 90 009
BLUETOOTH 4CH PUSH BUTTON INTERFACE
100 mm
the connections.
Installation Instruction
A
+ B
Enkel geschikt voor toestellen op zeer lage spanning (minder dan 50 V-AC / 120 V-DC)
Convient uniquement pour les produits à très basse tension (moins de 50 V-AC / 120 V-DC)
Geeignet für Güter mit sehr niedriger Spannung (unter 50 V-AC / 120 V-DC)
Only suited for goods at very low voltage (below 50 V-AC / 120 V-DC)
Se recomieda únicamente para aquellos productos de tensión muy baja (menos de 50 V-AC / 120 V-DC)
Vale unicamente per i prodotti a tensione molto bassa (inferiore a 50 V-AC / 120 V-DC)
Battery replacement
When battery indicator is showing a
low level a new battery will be needed.
Battery is available as spare part.
- Remove the cover (1) from the box (2).
- Pull out the pcb (3) slowly untill the battery
(4) can be removed.
- Replace battery and assure it is locked before
sliding the pcb back in and putting the lit cover.
Connection diagram
Wires connected to the external push buttons
We suggest to keep the wires long enough, so battery
replacement is possible witouth disconnecting the push buttons.
1
4
ery ery
before
3
cover.
Warning! Warning!
Only change battery with same type and rating Only change battery with same type and r
! !
1 1
External push buttons
Push button 1
Push button 2
Push button 3
Push button 4
Last Update ALLU 16/02/2018
2