Summary of Contents for Omni-Pro Software C3IWirelessGateway
- Page 1 C3IWirelessGateway Installation Manual Omni-Pro Software, Inc. 23608 458 Avenue Madison, SD 57042 C3IWireless Gateway Installation Manual 605-270-2285...
- Page 2 General Hardware Functionality • The C3IWireless Gateway is a load control and remote meter reading device suitable for municipal utility use. • NOTE: The screw terminals on the circuit board are to be tightened carefully or damage to the board could result. •...
- Page 3 C3IGateway Operation • The C3IWireless Gateway product line sends data to a master communications station via a digipeater network Each unit has an individual identification number station via a digipeater network. Each unit has an individual identification number. When data is needed from a unit, the computer polls the unit through the assigned digipeater path.
-
Page 4: Troubleshooting Communications
TROUBLESHOOTING COMMUNICATIONS • If a unit fails to report, the following might solve the problem: • FROM MASTER • Insure master is up and running, check to see if other units are reporting. If no units at all are reporting, reset master station computer. - Page 5 C3IWireless Gateway Functionality • Each gateway returns the following information when polled: • Normal Reading Poll • 4 Input Counters (Actual Meter Reading Accumulators) – Up to Two GE electric meters – Up to Two Absolute Digital Encoder Meters • 4 Status Inputs •...
- Page 6 C3IWireless Gateway Installation • Attach Gateway Enclosure • The C3IWireless Gateway features three mounting The C3IWireless Gateway features three mounting tabs to be used for mounting. Use lag screws or bolts appropriate to the structure the device is mounted to. The C3IWireless Gateway should be mounted close to the electric meter.
- Page 7 Attach Wiring Harness To Gateway • GATEWAY GE I210+ Harness • 12 VDC + • 12 VDC - Black Wire • RS 485+ Blue or Green Wire • RS 485- White Wire • Install GE Com Module Equipped Electric Meter •...
- Page 8 Absolute Encoding Register Meters • The C3IWireless Standard Gateway can read Sensus Absolute Digital Encoder type water and gas encoders. Encoder meters utilize a 3 wire connection to the C3IWireless Gateway. There are two available input ports for the encoders. The terminals are labeled R, G, and B and they are simply wired to the corresponding are simply wired to the corresponding...
- Page 9 • This device has been evaluated for compliance with rf exposure limits at a compliance with rf exposure limits at a distance of 20 cm. Installation of the device should be such that a minimum distance of 20 cm can be maintained between the radio antenna and nearby persons.
Need help?
Do you have a question about the C3IWirelessGateway and is the answer not in the manual?
Questions and answers