Advertisement
Warning & Safety Information
• Use caution when connecting cables to a power source as this may cause injury when not carried
out correctly.
• Designed for use in sheltered areas, protected from adverse weather such as rain.
• Do not look directly at LED lights as it can cause eye damage.
• A maximum of 6x50cm LED bars can be used of one circuit. Any additional bars may cause
overheating and damage to the items/circuits.
Troubleshooting
THE LED LIGHT IS NOT ILLUMINATING WHEN I SWITCH IT ON VIA THE ON/OFF SWITCH
Answer:
1. Check all connections are secure. Check power supply is plugged in and switched on. Some vehicle
cigarette sockets can have loose-fitting connections. Try pushing the cigarette plug in further. If this
still does not work you will need to use a different power source. You can connect directly to the
battery using the supplied alligator clamps.
2. If it is still not working, try unplugging the On/Off switch and connecting the LED directly to the power
source. If it now works you have located a problem in the On/Off switch.
3. If it is still not working contact 4WD Supacentre for assistance.
INSTALLATION
There are several ways the LED Bars can be installed:
1. Using the magnets at either end of each bar they can be connected to metal objects (not alloy). A
small metal washer can be super glued onto your awning poles. Ensure it does not interfere with
operation and installation of the awning.
2. A metal washer can be placed on top of the fabric and the LED can be magnetised through the
fabric.
3. Using the Velcro ties the LED bars can be attached to any of the horizontal or vertical alloy poles.
Ensure leads are neatly tucked away by running them behind any Velcro securing tabs.
Illuminator 5 Bar Camp Light Kit
2
Advertisement
