Medel SAMBA Quick User Manual

Business Unit Vibrant
SAMBA

Changing the battery

1.
To change the battery, hold the
device between two fingers. First open
one side of the battery case, then open
the other side.

Changing the cover

1.
First, remove the battery (see abo-
ve). Then place the Samba on an even
surface such as a table and put one
finger on top. First, lift one side of the
cover then lift the other side.
TM
Quick User Guide
2.
Open the battery case until the battery is
completely visible. Carefully turn the Samba
upside-down, allowing the battery to drop out.
2.
Remove the cover completely from the audio
processor. Place the new cover on the Samba by
positioning the rear side of the cover on the au-
dio processor first. Press the cover down: firstly
on the rear side, then on the front side. Make
sure that it snaps into place.
3.
Take a new battery and remove the sticky
tab from the top. Place the battery in the
audio processor's battery case. To activate
the Samba, slide the battery case into the
audio processor with two fingers.
3.
Press the sides together to ensure that
the cover is securely in position. Insert the
battery and close the battery case with two
fingers.