Advertisement
Quick Links
Advertisement
Summary of Contents for Jands Ezicom E101
- Page 1 E101 Ezicom Communications Belt Pack USER GUIDE...
- Page 2 Information contained in this manual is subject to change without notice and does not represent a commitment on the part of the vendor. JANDS Pty Ltd shall not be liable for any loss or damage whatsoever arising from the use of information or any error contained in this manual.
-
Page 3: Safety Precautions
INTRODUCTION The Jands Ezicom is a closed circuit headset intercom system which provides clear two- way communications even in high noise environments. A basic Ezicom system consists of one E401 master station connected to a number of remote E101 belt packs. -
Page 4: Equipment Description
EQUIPMENT DESCRIPTION 4, 5 (at rear) 1. Microphone Button Press this button to activate and deactivate the local headset microphone. This button glows green when the microphone is active. 2. Call Button Press to signal other people on the system that may not be wearing their headsets. This button also flashes red when another user on the system presses their call button. -
Page 5: Operation
CONNECTIONS The Ezicom and compatible communications systems use 3 pin shielded microphone cables for all interconnecting links. Only one power source (usually a Master) should be used in a system. Ensure all plugs are firmly seated in their sockets with the latches engaged. If possible make all connections before switching the power to the master station on - making con- nections while the power is on may disrupt other users and/or create clicks, pops, buzz, or other extraneous sounds. -
Page 6: Fault Finding Table
FAULT FINDING TABLE SYMPTOM CAUSE REMEDY E101 totally dead eg System power off Check Master power switches do not illu- switch minate, no sound in Mains power failure, power Check connections of the headsets, and turned off at wall socket or Master no response to but- disconnected... -
Page 7: Technical Data And Specifications
TECHNICAL DATA AND SPECIFICATIONS Mechanical PARAMETER VALUE Dimensions 200mm (W) x 110mm (H) x 55mm (D) Material Aluminium + ABS poly. Weight 330g Table 8.1 – Mechanical Specifications Electrical PARAMETER VALUE Supply 24-32VDC, 100mA max Line Signal Level 1mA/V Microphone type Dynamic Headphone Impedance 32-400 ohms...