Pto Switch; Ignition Switch; Brake Pedal; Seat Adjustment Lever - Simplicity 300 Series Operator's Manual

PTO Switch

The PTO (Power Take-Off) switch engages and
disengages attachments that use the PTO. To engage
the PTO, pull UP on the switch. Push DOWN to
disengage. Note that the operator must be seated firmly
in the tractor seat for the PTO to function.

Ignition Switch

The ignition switch starts and stops the engine, it has
three positions:
OFF Stops the engine and shuts off the
electrical system.
RUN Allows the engine to run and powers the
electrical system.
START Cranks the engine for starting.
NOTE: Never leave the ignition switch in the RUN
position with the engine stopped–this drains the battery.

Brake Pedal

Depressing the brake pedal applies the tractor brake.
Ground Speed Pedals
The tractor's forward ground speed is controlled by the
forward ground speed control pedal. The tractor's
reverse ground speed is controlled by the reverse
ground speed control pedal.
Depressing either pedal will increase ground speed.
Note that the further down the pedal is depressed, the
faster the tractor will travel.

Parking Brake

The parking brake knob is used to lock the parking brake
when the tractor is stopped. Fully depressing the brake
pedal and pulling up on the knob engages the parking
brake. Refer to page 10 for a full explanation of parking
brake functions.
Mower Height of Cut Adjustment
38", 44" & 50" MOWER DECKS
The cutting height adjustment knob controls the mower
cutting height. The cutting height is infinitely adjustable
between 1" and 3-5/8."
40" MOWER DECKS
The cutting height adjustment lever controls the mower
cutting height. Push down on the button to release the
lever, move to the desired cutting height, and release the
button to lock. The cutting height is infinitely adjustable
between 1" and 3-5/8."
Cutting Height Fine Tuning Adjustment
(40" Mower Decks Only)
The cutting height fine tuning adjustment is used to set
the mower cutting height between two of the preset
cutting positions.
Attachment Lift Control Lever
When using the mower deck, lift the deck off the ground
while transporting to and from the job site. DO NOT cut
with the mower in the raised, transport position.
The attachment lift control lever raises and lowers
attachments that utilize the tractor's manual lift linkage.
To lower an attachment: pull the lever back slightly,
depress the release button, and push the lever forward
until it locks in the lowered position. To raise an
attachment: push the lever forward slightly, depress the
release button, then pull the lever back until it locks in
the raised position.
Cruise Control (Select Models)
The cruise control is used to lock the ground speed
control in forward. Move the lever forward until the
desired ground speed is reached. To disengage the
cruise control move the lever back. In the event you
need to stop quickly, depressing the brake pedal will also
return the cruise control to neutral.

Seat Adjustment Lever

The seat can be adjusted forward and back. Move the
lever, position the seat as desired, and release the lever
to lock the seat into position.
Transmission Release Valve Lever
The transmission release valve lever deactivates the
transmission so that the tractor can be pushed by hand.
See PUSHING THE TRACTOR BY HAND for
operational information.
Fuel Tank
To remove the cap, turn counterclockwise. On models
with a dashboard display, the fuel gauge is part of the
dashboard. Models without a dashboard display have a
fuel gauge located under the seat.
12V
Power Outlet (Select Models)
The power outlet is 12V-DC. Accessory must be rated at
14 amps or less.
11
Features & Controls