Indeeco UHIR Series Installation Instructions

Select a heater installation location where the outlet air is not directed at an adjacent wall.
A. Radial Diffuser:
1. Loosen sheet metal screws located in the side of the heater cabinet to free directional louvers. Do not remove. Reference
Figure 1 below for location.
2. Remove directional louvers and retighten sheet metal screws from step 1.
3. Using the 8 supplied sheet metal screws, mount radial diffuser in pre-punched holes located in the heater cabinet as
shown in Figure 2.
4. Adjust louvers to direct airflow as desired.
B. Anemostat Diffuser:
1. Remove sheet metal screws and directional louvers as shown in Figure 1.
2. Remove front cabinet panel. See Figure 3 for attachment screw locations.
3. Using the supplied bolts, nuts and lock washers, install anemostat diffuser into the pre-punched holes in front panel.
4. Reinstall front heater cabinet panel.
INSTALLATION INSTRUCTIONS
DIFFUSER ACCESSORY KITS
UHIR Series Electric Unit Heater
Accessory kit installations should be performed by a qualified electrician.
Disconnect all power supplies before working on equipment.
Cabinet Size
(Reference heater nameplate)
1
2 & 3
4
INDEECO 425 Hanley Industrial Court • St. Louis, Missouri • 63144 • USA
(314) 644-4300 • FAX (314) 644-5332 •
WARNING
Radial
Diffuser Kit
1024152
1024153
1024154
www.indeeco.com
Anemostat
Diffuser Kit
1024155
1024156
1024157
ENM-2072-01 / 24-2241-83-1EF