Simplicity 2000 Series Installation Instructions Manual page 2

Installation Instructions
4. Attach the mounting plate (A, Figure 4) to the trans-
mission using two socket-head capscrews (B) as
shown. Torque capscrews to 60-65 ft. Ibs. DO NOT
over-torque. Be sure the alignment pins and O-rings
are facing toward the back of the tractor.
5. Grease the hydro pump output shaft with lithium
grease.
6. Align the input shaft of the PTO box with the output
shaft of the hydro pump and slide the PTO box into
position (see Figure 5). Be sure to push the PTO box
fully into position so that the alignment pins support
the weight of the box; DO NOT allow the hydro pump
output shaft to support the full weight of the PTO box.
7. Secure the PTO box to the mounting plate (A, Figure
5) using two 1/2-13x i-1/4 capscrews (B), lock wash-
ers (C), and nylon locknuts (D).
8. Secure the PTO box to the transmission using one
(C). Torque to 60-65 ft. Ibs. DO NOT over-torque.
9. Remove the fill level plug (G, Figure 5) and oil fill plug
runs out of the fill level hole. The PTO box oil capaci-
ty is approximately 16 oz (i/2 quart).
11. Reinstall the fill level and oil fill plugs.
Figure 4. Attach Mounting Plate
A. Mounting Plate
B. 112-13 x l-314 Socket Head Capscrews
Figure 5. Mount and Secure PTO Box
A. Mounting Plate
B. 1/2-13x t-114 Capscrew
C. Lo&washer
D. Locknut
E. l/2-13 x l-3/4 Capscrew
F. Fill Plug
G. Fill Level Plug
2
2000 RPM Rear PTO