HouseWarmer HWTMV-1 Installation Instructions

INSTRUCTIONS MUST BE LEFT WITH THE OWNER FOR FUTURE REFERENCE AFTER INSTALLATION

LOW VOLTAGE REED SWITCH THERMOSTAT INSTALLATION

1. REMOVE COVER OF THERMOSTAT FROM BASE AS SHOWN IN FIGURE 1.
2. DISCONNECT THE POWER SOURCE.
3. LOCATE IN AN AREA WITH GOOD AIR CIRCULATION (NO OUTSIDE WALL).
4. INSTALL THE THERMOSTAT AT APPROXIMATELY 5 FEET ABOVE FLOOR LEVEL.
5. USE ELECTRICAL WIRING APPROVED BY APPLICABLE CODES.
6. FEED WIRES THROUGH RECTANGULAR SLOTS AS SHOWN IN FIGURE 2.
7. CONNECT THE WIRES TO TERMINAL SCREWS AS SHOWN IN FIGURE 3.
8. MAKE SURE WIRING DOES NOT INTERFERE WITH THERMOSTAT'S OPERATION.
9. REPLACE THE COVER.
WARNING: IF THIS PRODUCT IS USED TO REPLACE A DEVICE CONTAINING MERCURY,
THE PURCHASER OR CONSUMER MUST ENSURE THAT THE MERCURY IS PROPERLY
MANAGED TO COMPLY WITH STATE OR FEDERAL REGULATIONS. THE MERCURY
MUST NOT BECOME PART OF SOLID WASTE OR WASTE WATER. ADDITIONAL
GUIDANCE MAY BE OBTAINED FROM THE MANUFACTURER OF THE PRODUCT BEING
REMOVED OR BY CALLING THE DIRECTOR OF ENVIRONMENTAL SERVICES.
OUTSIDE TENNESSEE: 1-800-251-7828
INSIDE TENNESSEE:
LOW VOLTAGE REED SWITCH THERMOSTAT
INSTALLATION INSTRUCTIONS
MODEL: HWTMV-1
1-423-477-4131
Figure 1
Figure 3
Reverso en español
Figure 2