OptoLum StreamLine Instructions Manual

OptoLum StreamLine Linear Light Strips
StreamLine HO, LO
SAVE THESE INSTRUCTIONS

Important Safety Instructions

a) Read all instructions.
b) Do not conceal or extend exposed conductors through a building wall.
c) Do not install this luminaire in wet or damp locations.
d) To reduce the risk of fire and burns, do not install this lighting system where the exposed bare
conductors can be shorted or contact any conductive material.
e) To reduce the risk of fire and overheating, make sure all connections are tight.
f) Do not install any luminaire closer than 6 inches (150mm) from any curtain, or similar
combustible materials.
g) Turn off electrical power before modifying the lighting system in any way.
GETTING STARTED
OptoLum StreamLine offers indoor cove lighting, display case lighting, and wall washing in a compact,
linear form. This guide contains important information on planning, installing, and operating your new
StreamLine Luminaire. For your protection, read it carefully and save it for future reference.
INCLUDED IN THIS BOX
1 - StreamLine Luminaire with mating power connector to attach to power supply.

1 - Set of mounting clips, or foam tape, or magnetic strips. Mounting clips are pre-drilled to

accommodate a #4 Pan Head Screw (Not Included). Foam tape and magnetic strips will be
pre-applied to StreamLine Luminaire at manufacturer specified locations.
1 - Installation Guide

ADDITIONAL ITEMS NEEDED
1 – UL Listed, Class 2, 24VDC power supply with mating secondary power connector that

matches to StreamLine power connector, and wire leads for connection to primary 120VAC.
#4 Pan Head Mounting Screws (1 per Mounting Clip)

Screwdriver

Drill

Level or Chalk Line

SCOPE OF THIS USER GUIDE
The goal of this user guide is to explain, in an easily understandable language, the necessary steps to
install StreamLine Luminaires and assure peak performance. Its intended use is for reference only, by
persons who are fully qualified. This document should never be considered a substitute for any
provision of a regulation or state and/or local code.
OWNER/USER RESPONSIBILITIES
It is the responsibility of the contractor, installer, purchaser, owner, and user to install, maintain, and
operate StreamLine Luminaires in such a manner as to comply with all state and local laws, ordinances,
regulations, and the American National Standard Institute Safety Code.
1 | S t r e a m L i n e 2 0 1 7