Advertisement
Quick Links
How To Set Up Your ZD420
1. Plug in the power cord into the printer
2.1 Plug in one end of the Ethernet cable into the printer and the other
end into the LAN Ports 1-4 of your router.
OR
2.2 Plug in one end of the USB cable into the printer and the other end
into your PC.
page 1 of 4
Choose
2
Rent
Phone 1 (800) 622-6484
Fax
1 (866) 937-8254
info@choose2rent.com
www.choose2rent.com
Advertisement
Summary of Contents for Choose 2 rent ZD420
- Page 1 1 (866) 937-8254 info@choose2rent.com www.choose2rent.com How To Set Up Your ZD420 1. Plug in the power cord into the printer 2.1 Plug in one end of the Ethernet cable into the printer and the other end into the LAN Ports 1-4 of your router.
- Page 2 Loading Your Badge Stock Option 1: FANFOLD 1. Open the printer by pulling the yellow tabs towards you. 2. Feed the badge stock from behind the printer. 3. Adjust the media guide to the corresponding stock size. 4. Leave a bit of paper sticking out beyond the lip and close. page 2 of 4...
- Page 3 Option 2: ROLL 1. Open the printer by pulling the yellow tabs towards you. 2. Push open the media guide and insert the roll of badge stock. 3. Be sure the paper is under the yellow guide tabs and extending beyond the lip of the printer and close the lid.
- Page 4 Calibrate Media PLEASE NOTE: the printer is set to Thermal Transfer (ribbon) by Default. This must be changed to Direct Thermal on your PC Zebra Utility Driver OR in your Guest Registration Software‘s Printer Utility Options. To calibrate your media press the following: 1.