Advertisement
Quick Links
Configure-8 Flip-Top
Handling, Operation & Maintenance
Tables
Manual
Ref. "C-8 FLT O&M Manual 26-04-11"
Burgess Furniture Ltd
Hanworth Trading Estate
Feltham
Middlesex
TW13 6EH
United Kingdom
Tel:
+44 (0)20 8894 9231
Fax:
+44 (0)20 8894 2943
Email: sales@burgessfurniture.com
Web:
www.burgessfurniture.com
Page 1/7
Advertisement
Summary of Contents for Burgess Furniture Configure-8 Flip-Top Table
- Page 1 Burgess Furniture Ltd Hanworth Trading Estate Feltham Middlesex TW13 6EH United Kingdom Tel: +44 (0)20 8894 9231 Fax: +44 (0)20 8894 2943 Email: sales@burgessfurniture.com Web: www.burgessfurniture.com Configure-8 Flip-Top Tables Handling, Operation & Maintenance Manual Ref. “C-8 FLT O&M Manual 26-04-11”...
-
Page 2: Table Of Contents
CONTENTS SECTION PAGE Section 1- Introduction About This Manual Health & Safety (UK) Section 2 – Handling, Storage & Operation Handling Storage Operation Section 3 – Maintenance & Repair General Maintenance Schedule Cleaning Inspection & Repair Lubrication Ref. “C-8 FLT O&M Manual 26-04-11” Page 2/7... -
Page 3: Section 1- Introduction
1.1.4 All relevant diagrams are to be found within this manual. 1.1.5 Burgess Furniture cannot be held liable for any loss, damage or injury resulting from failure to follow the procedures given. Health & Safety (UK) 1.2.1 It is the Employers duty under the Health &... -
Page 4: Section 2 - Handling, Storage & Operation
SECTION 2 – HANDLING, STORAGE & OPERATION Handling 2.1.1 Configure-8 Flip-Top tables are fitted with castors enabling the tables to be wheeled around on smooth or carpeted floors. 2.1.2 Where possible the tables should be moved as described above. However, if it necessary to lift the tables it is recommended that this should be done by two personnel. -
Page 5: Operation
Operation 2.3.1 Observing the handling instructions (see 2.1 Handling) position the table where required. 2.3.2 Lower the top to rest on the underframe. • DO NOT place hands or fingers in the hinge assembly or drop the top! 2.3.3 Push down on the top to ensure both latches have engaged. 2.3.4 To release the top, operate the release handle by turning in either direction, then lift the top to its upright position. -
Page 6: Section 3 - Maintenance & Repair
3.1.3 Light damage as outlined below may be repaired by (or by agents of) the operator. More severe damage should be referred to Burgess Furniture Ltd. 3.1.4 Intended Use: The table is suitable for use in general non-domestic environments such as meeting rooms. -
Page 7: Lubrication
If missing or broken, the linking clips can be replaced by unscrewing the relevant corner moulding, replacing the linking clip, then refitting the screws to secure the corner moulding. 3.4.8 More severe damage should be referred to Burgess Furniture Ltd. • ANY DEFECTIVE TABLES MUST BE REMOVED FROM SERVICE IMMEDIATELY. Lubrication The Configure-8 Flip-Top should not need any specific lubrication.