Advertisement
FITTING INSTRUCTIONS • MFI
CALYPSO MODENA BATHROOM FURNITURE
Only use the drilling guide on this fi tting instruction. The pilot holes on the reverse of the fascia are for alternative units.
Gallery Rail
attachment to
fascia 10mm ø x
12mm deep
Rear left side
of fascia
x
Drawer fascia
attachment
x
32mm
Bottom
left rear corner
of fascia
PLEASE NOTE:
How to fi t
1.
Remove drawer from unit by removing 'CALYPSO' badge from drawer box sides, lift the
release lever 'E' and slide drawer forward to remove.
2.
Mark desired position of unit on the wall and mark top of carcass position (NB - The
standard fi xing height is 811mm from fl oor to top of carcass.
3.
Fit wall plate to wall using fi xings suitable for wall substrate. FIG1. Brown plugs and 60mm
screws are supplied for use where wall substrate is suitable.
4.
Hang unit on wall hangers and adjust for height and level then pull tight to wall - FIG2.
5.
Fix basin to carcass side walls with silicone and plumb in tap and waste.
6.
Mark and Drill rear of fascia using drill guide provided on these instructions.
NB. DO NOT USE THE PIN PRICK POSITIONS ALREADY ON THE FASCIA.
Place this paper template this side up onto the bottom rear corners of the fascia and drill small
pilot holes through the paper over the 'x' marks and a 10mm diameter by 12mm
•
deep hole at the '
' marks.
7.
Remove template paper and attach Alloy fascia brackets and Gallery Rail attachment from
drawer system to fascia.
8.
Check runners are clear from dust and push drawer back onto the runners.
9.
The fascia is adjustable:
• Left/Right - via adjustment 'A' (found on the right hand side only)
• Up/Down - via adjustment 'B'
• In/Out - slide the sleeve 'C' back and rotate the adjuster 'D' to tilt the fascia.
10. Ensure basin and unit are adequately sealed with silicone to prevent water ingress to carcass material.
NB. To remove drawer fascia from drawer box, unclip the Gallery Rail and turn 'F' on both sides.
FIG1.
35mm
F.
A.
B.
Carcass Top
FIG2.
Lock Screw
Up/Down
30mm
D.
E.
Do Not Scale
x
x
C.
Gallery Rail
attachment to
fascia 10mm ø x
12mm deep
Rear Right side
of fascia
Drawer fascia
attachment
32mm
Bottom Right
rear corner of
fascia
Advertisement
