Baby Banz EP102 Operation Instructions

GB
TYPE： ： ： ： EP132
Operation Instructions for EP102 Bluetooth Electronic Earmuff
STEP I / Match ID code:
1.
Press the ON/OFF button and hold for 4 seconds, green LED will start flashing.
2.
Turn on the cell phone or PC (or other device) to search the ID: BabyBanz
3.
After connecting, the green LED will show a continuous light.
4.
The device will connect automatically at the next operation.
STEP II / Audio operation:
1. Turn on the music program within the cell phone or PC (or other device), the earmuff will connect
automatically and play audio.
2. To turn off, press and hold ON/OFF button for 2 seconds
STEP III / USB charger:
1.
Red LED will be on when the USB charger is connected. The red LED will turn off once the device is fully
charged.
2.
When the device needs recharging, the LED will start flashing red.
3.
The device will turn-off automatically when the voltage is too low.
FCC Statement:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation.
Baby Banz Ear Protectors