Safety and warning information Read this user manual All safety and operating instructions in this user manual should be read before operating the product Keep this user manual This user manual should be retained for future references. Head Warnings Be cautious about warning signals on the product. Follow Instructions Please follow instructions in this user manual Attachments...
Page 4
Avoid over heat Do not place heavy objects on top of the unit and at sealed areas to avoid heat ventilation problems. Product Protection Please do not place any attachment or parts inside the product to avoid contacts with voltage points that could result an electric shock or fire.
Page 5
Overloading Do not overload wall outlets, extension cords or integral convenience receptacles as this can result in a risk of fire or electric shock. Damage Handling Unplug this product from the outlet of wall and request qualified service personnel under the following conditions: •...
Page 6
Storage Keep the product at dim areas, room temperature and low humidity to maintain original condition. This will avoid danger. Transportation Since the product consists of glass and delicate electronic components, excessive shock or drop will result damages. Please handle the product carefully to minimize shock during transportation. Recycling The product utilizes tin-lead solder, and has a fluorescent lamp containing a small amount of mercury.
Product over view Vega offers different interfaces as well on the rear as on the front side. All interfaces are integrated and functional on Android level and can be accessed from custom applications through corresponding libraries.
Page 9
Rear Input/Output GPIO-104 GPIO-GND RS232-GND RS232-TXD RS232-RXD RS485-B RS485-A DC in 12V DC in GND KNX- RJ45/POE KNX+ Line out 5V: Power output 5V, USB port Max300ma GPIO-101 Function button A (Is used by open setting) GPIO-102 Function button B (Is used by open setting) GPIO-103...
Installation & Quick start Gang box installation Cut an area of Vega location on the wall Use screw or glue to hold on the Gang box VEG073 Portrait: 128(W) *227(L) MM VEG101 Landscape: 288(W)*179(L) MM...
Page 11
Connect cable Connect the DC cable and Lan cable from the wall to VEGA I/O port. Note: POE is also connect to to the same port.
Page 12
Magnet Adjust the magnet to fit to the Gang box.
Page 13
Install Vega Place the Vega into the Gang box and the front cover into the Vega. Connect to Wi-Fi Go to the Android setting and select Wi-Fi Select the network or source you wish to connect to from the list...
Page 14
Once the Gang box installation of the wall has been completed, the RS232/ RS485 / GPIO/ KNX wire and power cable is connected, the device will power on. If the screen is not display anything, check the power support was connected well. license and regulation This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
Page 15
Change or modifications that are not expressly approved by the manufacturer could void the user’s authority to operate the equipment. FCC Radiation Exposure Statement The antennas used for this transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must not be co-located for operating in conjunction with any other antenna or transmitter.