Summary of Contents for Hapstone M2
-
Page 2: Technical Specs
Sharpener base. Vertical rod. Fixing ring. Horizontal rod with pivot unit. Sharpening stones set. Black marker. User Guide. Technical specs ❖ Knife sharpener dimensions (ready to work): 45х13х18.5 cm; ❖ Maximum sharpening stone length: 15 cm; ❖ Knife sharpener weight: 1.52 kg. - Page 3 Setup Assembling Insert the vertical rod (2) into the sharpener base (1) from the bottom. Put the fixing ring (3) on to the vertical rod on the opposite side of the base. The fixing ring should touch the base and prevent vertical movement of the vertical rod. Tighten the fixing ring. The pivot unit is mounted on the horizontal rod (4).
- Page 4 Fastening the knife Position the knife on the rubber mat at the base of the knife sharpener. The edge of a knife with a blade should be directed outwards (towards you). You will immediately feel the magnet located in the front part of the base. The cutting edge of the knife must slightly overlap the edge of the base (approximately 1-3 mm).
- Page 5 Note: When you read about knife sharpening, you may come across the term “full sharpening angle.” This means the sum of the two angles used to sharpen both sides of a blade (e.g. 15 one side + 15 the other side = 30 full sharpening angle). As a result, when using the Hapstone, you need to divide the value of the full angle by 2 to get the value of the angle you need to set on the Hapstone.
- Page 6 Precautions Hapstone knife sharpener is made of steel and covered with a high-quality coating. It can be used in any conditions. It can be conveniently placed on any surface and its rubber-tipped legs prevent it from sliding while sharpening. While sharpening a knife, observe all necessary safety measures. Be careful not to injure your hand on the sharpened blade of your knife.