Advertisement
Quick Links
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for NUTRICHEF PKSJ40
Summary of Contents for NUTRICHEF PKSJ40
- Page 2 Slow Juicer User’s Guide This is a picture diagram only and slight changes to the product could be made Don't connect to the power before you complete the reading of this manual. Please properly retain this manual for future reference. PKSJ40...
- Page 3 Features 1. This modern designed juicer uses a non-grinding method featured by slow squeezing. Therefore, the natural flavors and nutrients of the fruits and vegetables are well retained. This product has multiple functions, including making vegetable juice, fruit juice, etc. 2.
- Page 4 13. If the power cord is damaged, it must be replaced by the manufacturer or the manufacturer’s designated service agent/center. 14. When you are pulling the power cord out of its power source, be sure to pull from the plug-end and not the cord itself. Also, do not operate the plug with wet hands.
- Page 5 Schematic Diagrams for Parts...
-
Page 6: Assembly Method
Assembly Method 1. Place the squeezing cup inside the main body of the juicer. Make sure to use the fixed point position while inserting the squeezing cup. - Page 7 2. Put the squeezing barrel into the washing rack. 3. Place the already assembled squeezing barrel and washing rack into the squeezing cup. *While installing, please make sure the marking point on the squeezing barrel aligns with that on the squeezing cup...
- Page 8 4. Place the spiral propeller into the squeezing barrel. 5. Install the squeezing body cover. Install the squeezing body cover downwards; the marking point on squeezing body cover should align with that on the squeezing cup. After the squeezing body cover is placed, locate the “ ” symbol at the edge of the squeezing body cover; rotate this in a clockwise direction towards the ”...
- Page 9 Assembly of Rubber Squeezing Pad After the squeezing rubber pad is pulled out for cleaning, reinstall it by following the directions below: On/Forward: Will push the fruits and vegetables downwards for squeezing. Reverse: This will return the fruits and vegetables upwards; use this if there is blockage. Notes: Please do not use wet hands while operating the switch or any other parts of this juicer.
- Page 10 Place the (already cleaned) fruits and vegetables into the feed inlet; push the fruits and vegetables inwards by using the pushing rod. If the fruit or vegetable is too large for the feed inlet, cut them into small enough blocks and insert them. Note: Please use only fresh fruits and vegetables to make juice.
-
Page 11: Disassembly Method
After the squeezing process is completed, please press the stop switch, and pull the power plug out. Warning: Please do not store the juice for a long period of time. This machine is not built to crush grains (motor clamp and/or mechanical failure may be caused). Disassembly Method 1. - Page 12 3. Hold the juice outlet on the squeezing cup and take it out (see figure ③). 4. Take out the spiral propeller, squeezing barrel, and washing rack in the squeezing cup (see the figure).
-
Page 13: Cleaning Method
5. Disassemble the spiral propeller, squeezing barrel and washing rack. Cleaning Method 1. Wash the disassembled parts with flowing water; if the meshes are blocked up by pulp, please use the cleaning brush. Note: Please do not use an iron wire brush or sharp cleaning tool for the cleaning these parts. - Page 14 2. Do not place the mainframe in water for cleaning. Be sure to use a soft cloth to clean it. 3. After cleaning, please dry the cleaned parts and store them in a clean and well ventilated place. Notes: 1. Please wash the machine after use. Otherwise, the pulp and waste will attach to the container, which will affect the assembly and cleaning and even result in performance reduction.
-
Page 15: Troubleshooting
Product Specs and Main Parameters Nominal voltage Nominal frequency Nominal power Nominal time ≤20min 110V 60Hz 200W Trouble Shooting Problem Cause Troubleshooting Method The juicer stops suddenly A. The power plug is not A. Make sure the plug is inserted correctly inserted into the socket B. - Page 16 vegetables, and please do not worry about it. The container and A. Pulp and waste has A. Clean the machine after accessories have become attached itself to the stained with a different container B. Clean the machine with color B. The container and detergent/washing soap accessories are liable to have their colors changed...
Need help?
Do you have a question about the PKSJ40 and is the answer not in the manual?
Questions and answers