1. Manuals
  2. Brands
  3. Rousseau Manuals
  4. Saw
  5. 2850
  6. Owner's manual

Rousseau 2850 Owner's Manual

Miter saw/planer stand kit
Hide thumbs
Table of Contents

Advertisement

Quick Links

Download this manual
Quality Power Tool Accessories
Assembled Unit Shown
Without Shelves & Wings
Assembled With
Shelves & Wings
Miter Saw/Planer Stand Kit
Read and understand all safety guidelines and
OWNER'S MANUAL
Model 2850
IMPORTANT
instructions carefully before operating.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 2850 and is the answer not in the manual?

Questions and answers

Related Manuals for Rousseau 2850

Summary of Contents for Rousseau 2850

  • Page 1 Quality Power Tool Accessories OWNER’S MANUAL Assembled Unit Shown Without Shelves & Wings Assembled With Shelves & Wings Miter Saw/Planer Stand Kit Model 2850 IMPORTANT Read and understand all safety guidelines and instructions carefully before operating.
  • Page 2 GENERAL INFORMATION You have purchased a Rousseau Co. MODEL 2850 MITER SAW / PLANER STAND KIT. This unit sets up quickly, and is mobile with locking casters. It is especially useful to finish carpenters and cabinet or furniture builders. WARRANTY This product has a lifetime warranty to the original purchaser.
  • Page 3 TOOLS NEEDED Measuring Tape Pencil 7/16”, 1/2” Wrench Hammer 7/16”, 1/2” Ratchet Phillips Screw Driver “C” Clamp Drill 10. 1/4” Drill Bit 11. #8 or Similar Counter Sink Bit 12. Long Straight Edge 13. AWL HARDWARE INCLUDED M. 4 Wing Support Rods 40 1/4”...
  • Page 4 Step 1 MEASURE SAW HEIGHT Measure saw height as shown in FIG 1 Step 2 FRAME ASSEMBLY A. Using measurement from Step 1. plus 1-3/16”, mea- sure down from the top of all 4 corner posts (D) and make a mark. Mount cross member (E) to corner post using (D) bolts (A) and nuts (B).
  • Page 5 Step 4 SQUARING FRAME ASSEMBLY A. Semi-tighten one bolt on each edge of front before squaring. B. Measure diagonally both ways on front of unit. Shift frame until measure- ments are equal. Then tighten middle and bottom nuts. (Fig. 4) C.
  • Page 6 Step 7 MOUNTING SHELVES A. Secure shelf (AA) on top, (BB) in middle and (CC) on bottom. Using bolts (C) & nuts (B), thumb tighten. B. Make sure frame is square (see step 4 for squaring instructions) then tighten shelf nuts until screw heads are flush.
  • Page 7 MOUNTING THE MITER SAW (FIG. 10) Step 1 WING & SHELF ADJUSTMENT A. Set saw onto stand and place a straight edge across the saw. B. If the top of the saw bed is not flush with the top of the wings loosen the nuts securing the top cross member (E) at one corner.
  • Page 8 F. If the top of the 2850 wings are not level with the planer wings, they can be adjusted by loosening the three screws in the wing support guide (L). Level the 2850 wing and tighten screws. Repeat for opposite wings.

Table of Contents