Summary of Contents for WaveIP GigAccess OFDM 900
- Page 1 August 2005 GigAccess GigAccess OFDM 900 OFDM 900 GigAccess GigAccess OFDM 900 OFDM 900 Self Self- - - - Install RSU Self Self Install RSU Install RSU Install RSU User Guide User Guide User Guide User Guide...
-
Page 2: Table Of Contents
Table of Contents 1. INTRODUCTION ......................3 1.1. G ..........................3 ENERAL 1.2. G OFDM 900 S ..............3 CCESS YSTEM VERVIEW 2. PACKING LIST......................4 3. INSTALLATION PROCESS ..................5 3.1. G ..........................5 ENERAL 3.2. B ......................6 EFORE TART 3.3. I ........................6 NSTALLATION 3.4. R ....................7 ADIO HANNEL... -
Page 3: Introduction
1. Introduction 1.1. General Congratulations on your purchase of the WaveIP GigAccess™ OFDM 900 self-install Business/Residential Subscriber Unit (RSU). This document describes how to install and use your subscriber unit to obtain wireless high-speed Internet access. You can connect your RSU both to a computer and to a local area network (LAN) through the integrated two ports. -
Page 4: Packing List
2. Packing List When you first open the package, verify that the unit is complete and consists: • RSU Unit • Power Supply • Quick Start Guide Figure 2-1 illustrates the RSU package contents. Quick Start GiAccess Guide Self-Install RSU User Guide Figure 2-1: RSU package contents Page 4 of 4... -
Page 5: Installation Process
3. Installation Process 3.1. General The RSU is a self-installed, plug and play unit, which requires minimum operation from the user. A description of the RSU is given in the figure below. 1. Polarization Indication 2. Air link led (Green) 3. -
Page 6: Before You Start
3.2. Before You Start 1) Make sure your computer is equipped with an Ethernet Network Interface (NIC) 2) Make sure your computer is set up to automatically obtain an IP address (See 0). 3) Select the appropriate location for the RSU: •... -
Page 7: Radio Channel Selection
Direction Power Supply Ethernet Data Cable 100-240V AC CAT5 Figure 3-2: GigAccess™ RSU - Installation Scheme 3.4. Radio Channel Selection The radio channel is defined at the AU side. The RSU is pre-configured to scan all channels. Therefore it will acquire the AU channel automatically. -
Page 8: Fcc Information
Any unauthorized modification or changes to this device without the express approval of WaveIP may void the user’s authority to operate this device. Furthermore, this device intended to be used only when installed in accordance with the instructions outlined in this manual. -
Page 9: Gigaccess Tm Ofdm 900 Rsu Technical Specifications
4. GigAccess OFDM 900 RSU Technical Specifications Operating Frequency 902 – 928MHz ISM band Number of Channels 7 (912 – 918) in step of 1MHz Access technology TDMA (Time division multiple access) Duplexing schemes TDD (Time division duplex) RF Waveform OFDM Raw Data Rates 6, 18 Mbps...