EVannex Front Lighted T Installation Instructions

For tesla model s

Advertisement

Tesla
Model
 
Installation
Instructions

 
The
front
lighted
 
 
other
cars
on
the
 
 
 
 
mounted
under
Tesla's
 
 
With the supplied remote control the device can be turned on and off at will, its
brightness dimmed or intensified, and special effects such as flashing displayed.
In tandem with the rear lighted T the effects of the lighted Ts on the appearance of
the car win much public attention and admiration.
 
 
 
TESLA
MODEL
S
FRONT
S
Front
 
 
T
makes
your
Tesla
 
 
 
 
road
and
other
Model
 
 
 
standard
chrome
 
 
 
 
 
LIGHTED
T
INSTALLATION
Lighted
 
Model
S
distinctive
 
 
 
S's.
This
LED
powered
 
  
 
 
T
and
arch
on
 
 
 
 
T
 
if
not
unique
from

 
 
 
 
device
is

 
 
the
front
of
the
car.

 
 
 
 
 
1

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Front Lighted T and is the answer not in the manual?

Questions and answers

Summary of Contents for EVannex Front Lighted T

  • Page 1: Installation Instructions

    Tesla Model Front Lighted           Installation Instructions
   front lighted makes your Tesla Model distinctive unique from
                           other cars road other Model S’s. This powered device...
  • Page 2 Parts Supplied • 15 feet 2-lead black and red 20 gauge stranded wire • OBD2 connector (for 12v power and ground connections) • 5 feet Spectra nylon parachute thread • Mini LED RF wireless remote control • 12v pre-wired LED for dash mounting •...
  • Page 3 A. Remove nose cone The nose cone is attached to the front structure with a 
 number of spring clips. Using a plastic pry tool pry loose one of the bottom right or left edges and remove the nose cone. It the car is equipped with parking sensors or other nose-cone mounted electronics, unplug the electrical connections and set the nose cone aside.
  • Page 4 
 Tap 12v power and ground An always on 12v connection and ground is necessary for proper functioning if the Lighted T. The OBD2 connector is provided for this purpose. Pin 16 provides the 12v connection and pins 4 or 5 ground. Solder a 18”...
  • Page 5 Connect the LED Controller to Front T & Arch and LED dash indicator. Using Posi-Lock connectors attach the short red and black leads from the LED Controller to the red and black leads on the prewired dash LED. This LED will light when the Front T and Arch are turned on, thus providing an indication about its operation from inside the car.

Table of Contents