Fitting The Pitch Control - Kestrel e300i User Manual

e300i User Manual
Approval:

3. 3. 3. 3.8 8 8 8 Fitting the Pitch Control

Fitting the Pitch Control Fitting the Pitch Control Fitting the Pitch Control
The generator is a complete unit. The shaft drive key is factory fitted
to the generator shaft with a cable-tie. Remove cable-tie, before
fitting pitch control.
Offer the pitch control hub to the shaft and
slide it onto the shaft.
It is important that the bolt is secured with Locktite.
Document #: 0503M01A
Date: March '08
Smear waterproof grease (30) over the shaft and insert a little
inside the front of the generator where the shaft projects out.
Using a hexagon key, fit the front shaft bolt (15) and washer (14) to
the spring locking washer provided into the generator shaft and
tighten the assembly.
REV : 1.3
Page 10 of 25
10