Advertisement
Components
•
JTECH Transmitter
Applies to models: IQ Base, NEO, IStation
•
Coaster Pagers
•
Coaster Charger
Step 1
Lock the antenna to the connector on the
transmitter by placing the antenna on the
connector and twisting left to lock in place.
Step 4
Add pagers to base. You will see a BLUE light on
each pager. This light indicates the charging
status.
©2017 JTECH, an HME Company logo and product names are registered trademarks of HM Electronics, Inc. All rights reserved.
GuestCall
Step 2
Plug the power supply into the transmitter and
then into a standard 110-240v outlet. A surge
protector is recommended.
•
'LO' on the number display: Battery is below 20% charged and SHOULD NOT be used.
•
Flashing BLUE: Pager is charging and CAN BE used.
•
Solid BLUE: Pager is fully charged.
•
Allow 4 hours for a complete charge of the pagers.
®
Paging w/ Coaster Pagers
Quick Setup Guide
Connector Wire
Step 3
Compile charger bases and connector wires if
applicable. Plug charger power supply into
charger and then into a standard outlet. Surge
protection is recommended for charging bases.
PM17001-C
P
Advertisement
Table of Contents
Related Manuals for JTECH GuestCall Coaster Pager
Summary of Contents for JTECH GuestCall Coaster Pager
- Page 1 This light indicates the charging Solid BLUE: Pager is fully charged. status. • Allow 4 hours for a complete charge of the pagers. PM17001-C ©2017 JTECH, an HME Company logo and product names are registered trademarks of HM Electronics, Inc. All rights reserved.
- Page 2 1. Enter in the 1 to 4-digit pager number into the transmitter and press SEND. 2. The pager will alert until it is returned to the charger. Additional information available at www.jtech.com/support. ©2017 JTECH, an HME Company logo and product names are registered trademarks of HM Electronics, Inc. All rights reserved.
Need help?
Do you have a question about the GuestCall Coaster Pager and is the answer not in the manual?
Questions and answers