Advertisement
Go!
Status
LED
1
Home
Away
3,5
Status
LED
4
Home
Away
flashing green, indicating that it has acquired
the House ID. Press and hold
seconds again on the same previously
installed device to terminate.
Use
Radio Range Boost
Once the repeater is bound to the House, just
leave it alone and it will receive and
retransmit all radioMiro
that House, effectively doubling the range of
all House devices.
Occupancy Emulation
The repeater builds up a 7-day record of
actual network traffic, and constantly keeps it
up to date, to account for seasonal variations
Status
in lighting use.
LED
1. Press the Away button, and one minute
later (time to leave the house), the
repeater will start playing back a real-life
seven-day loop of radioMiro
commands. It will be just like the last
week you spent at home.
2. When you come back, pressing Home, or
any button on any radioMiro
2
Home
Away
the home, cancels occupancy emulation.
Assigning Occupancy Emulation to a
House Preset
Since the repeater may not be easy to reach,
there's a better way to launch occupancy
emulation – assign it to a House Preset.
3. From a house preset controller, press
for 2 seconds, followed by the preset
button you want to use – we suggest the
bottom one.
4. Now go to the repeater and press both
buttons for 2 seconds, assigning it to the
house preset. The repeater status LED
blinks yellow. Important – one repeater
only should be assigned to the house
preset (if you have more than one
repeater, use the most centrally located).
If there are other devices in the house
already assigned to the preset (blinking
yellow), deselect them by pressing
2 seconds (they will blink green).
5. Return to the preset controller and press
for 2 seconds to terminate.
6
6. When you leave the house, press the
house preset button you just recorded,
and one minute later, occupancy
emulation will begin.
Cleaning
Clean only using a cloth dampened with
water and a little mild detergent.
Use of solvents or hydrocarbon-based
cleaners may cause permanent damage.
Troubleshooting
Problem: I messed up the configuration, and
I need to clear down and start again.
You can reset any radioMiro
factory default settings by pressing and
holding for 10 seconds. The LED reverts to
yellow, indicating that factory settings have
been restored.
for 2
network traffic for
TM
TM
device in
TM
for
device to
TM
Advertisement
