Do you have a question about the MONSOON and is the answer not in the manual?
Questions and answers
Summary of Contents for Senitron MONSOON
Page 1
SENITRON MONSOON UHF RFID READER Senitron Corporation 3/3/2015...
Page 2
FCC Statement NOTICE; A. The RFID Reader module is limited to OEM installation ONLY. The OEM integrator is responsible for the compliance to all the rules that apply to the product into which this certified RFID Reader module is integrated. B.
Page 3
This device is intended only for OEM integrators under the following conditions: The antenna must be installed such that minimum 20 cm is maintained between the antenna and users, and the RFID Reader module may not be co-located with any other transmitter or antenna set forth in section 2 above.
Page 5
INTRODUCTION The Senitron MONSOON™ UHF RFID Reader pushes the price-performance limits of EPC Gen 2 RFID tag & reader systems. The MONSOON™ reader is based on the Impinj® R2000 chipset, providing high sensitivity and advanced noise handling. TCP/IP connectivity and power handling are performed via an integrated Power-over-Ethernet module (PoE), for ‘single-cable’...
Page 6
SETUP The MONSOON™ reader is designed to be easy to set up and install. Simply follow the following steps: 1. Connect an ethernet cable from a standard IEEE 802.3af compliant PoE switch to the PoE port on the reader. The MONSOON™ reader can accept DHCP ip address assignments or be assigned a static IP address upon setup.
Page 7
Figure 5: Inventory Cycle Start RFID raw read data is stored in comma separated value (CSV text file) format in the MONSOON directory. CSV files are readily compatible for input to spreadsheet and relational database software for further analysis. SUPPORT Senitron recommends completing a full software and installation design review prior to implementation.
Need help?
Do you have a question about the MONSOON and is the answer not in the manual?
Questions and answers