Bluetooth: used for pairing with Bluetooth devices Hands-free phone calls: After Bluetooth pairing successfully starts the speakerphone to answer phone calls Volume +/-key: control the volume level (press “-” to reduce the volume, press“+” to increase the volume). Lamp touch switch: control the LED light on and off. MIC: use for receiving sound when starts Hands-free phone calls.
Page 4
Accessories Please check and confirm the accessories below. power cable adapter Operating Instructions Connecting the AC adapter 1. Insert AC100-240V~50/60HZ to AC adapter. 2. Connect the AC adapter output cable to DC IN. Unit on/off Turn the power switch at the bottom to “On”. Then Bluetooth speaker lamp enters into standby mode and a voice alert “du”...
Page 5
re-connection is successful in 2 minutes.(Music source LED indicator will turn blue and flash for 3 seconds and a sound alert “du” will be heard after the unit is power on. Music source LED indicator will flash alternately between red & blue and a sound alert “dudu”...
Page 6
addition, the speaker volume adjustment can be achieved by adjusting the volume of your smart phone. Hands-free phone 1. After Bluetooth successful pairing, Single-press key to open the Hands-free phone when your call comes in your smart phone. 2. Single press key to pause when you are playing music.
Page 7
stays on Blue after connection and music can be played via Bluetooth. Built-in Li-ion Battery Battery charging time: 4~6 hours Support up to 3~4 hours music playing /lighting Battery charging indicator The power LED indicator stays on and turns blue when charging the battery. The power LED indicator turns red when charge fully.
Page 8
Amplifier Power output 10 W X 1ch(1kHz@4Ω) T.H.D Loudspeaker Type built-in Nominal impedance 4Ω Rated power input 15 W Maximum power input 20 W Lamplight Maximum power Maximum brightness 1050 lx(20cm distance) Brightness adjustment three levels light-dimmer Instructions to adjust the light Step 1: push up the lamp panel ...
Page 9
Step 2: pull out the lamp panel to the fix location Step 3: Adjust the lamp panel up to 35 ° ...
FCC Statement: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.