Installing A Diversity Tuner Module (Urx-M1) - Sony UWP-X5 Operating Instructions Manual

Installing a diversity tuner
module (URX-M1)
Notes
• Before installing the diversity tuner
module (URX-M1), make sure the unit
into which the tuner module will be
installed is turned off. Do not install or
uninstall the tuner module while the unit
into which the tuner module will be
installed is turned on, as this may damage
the connector or cause noise.
• The buttons and display on the front
panel of the tuner module may be
damaged if they are gripped too strongly.
Always hold the tuner module by the
side.
• Do not put your fingers on the connectors
on the rear panel of the tuner module or
into the slot on the unit into which the
tuner module will be installed.
• Keep the tuner module away from static
electricity.
To install a diversity tuner
module (URX-M1) into an MB-
X6 Tuner Base Unit
The MB-X6 Tuner Base Unit can
accommodate up to 6 diversity tuner
modules (URX-M1).
1
Loosen the screws at both sides of the
front cover, then slide the front cover
downward.
2
Hold the screws by the head and pull
forward to remove the front cover.
20 Attachment and Installation Procedures
3
When installing the tuner unit into the
tuner slot other than slot 1, push the
corresponding blank panel from the
front side of the front cover to remove
it.
4
Insert the tuner unit into the slot until
you hear a click.
5
Match the six latches with the six holes
on the front panel, then replace the
front cover.
6
Tighten the screws on the front cover
to secure it to the front panel of the
MB-X6.