Advertisement
Operating and Installation Instructions
1. Protection and maintenance
in order to ensure smooth operation never expose the system to extreme sunlight, high temperatures, moisture or dust over long
periods of time. do not operate under excessive vibration and never remove the protective speaker grille. in case of a defect please
contact MusiC stORe service and do not open the device!
2. Avoiding interactions
do not operate the device near a radio or television. this could lead to hum and other unwanted noises. When connecting other
equipment avoid ground loops. should you still hear a humming noise, you can prevent this by pressing the sHield switch located
on the control panel.
3. Connections
Before connecting the passive speaker to the electricity grid, please ensure that the electrical power supply corresponds with the
voltage indicated on the device (+/- 10% tolerance is allowed). Only turn the device on after you have plugged in the power cord.
also, turn the device off before unplugging the power cord. any further connection of cables should be done when the device is
switched off. the mixer should be turned on before turning on the device. this prevents annoying and dangerous switch-on noises.
4. Cables
When connecting a mixer to the device please make sure to only use intact and screened cables. Cables without electrical screen-
ing can cause problems due to signal or hum interferences. When connecting satellites to the bass speaker please use sPeaKOn
cables of good quality. Check your cables' condition regularly.
5. Control panel
Manufacturer:
MUSIC STORE professional GmbH
Istanbulstraße 22-26, 51103 Köln
Tel: +49 (0) 221-88 84 -0
E-Mail: info@musicstore.de
Service:
MUSIC STORE professional GmbH
Istanbulstraße 22-26, 51103 Köln
Tel: +49 (0) 221-88 84 -3620
E-Mail: info@musicstore.de
7
Advertisement
