black forest motion 3D-Photogrammetry Bundle Quick Start Manual

Black Forest Motion
3D Bundle – Quick Start Guide
Thank you and congratulations for purchasing
the Black Forest Motion 3D photogrammetry
bundle. This guide will help you with the first
steps to set-up the system. For a quick start
guide focusing on the PINE Motion Controller,
see our separate guide which is included with
each controller.
Bundle Parts
• PINE Motion Controller
• Power supply
• Nic-O-Tilt Head
• Motor Cable 2.0m
• Motor Cable 1.5m
• Motor Cable 0.5m
• Turntable disk
• Slider Rail
• Motor attachment
Motor assembly (120cm only)
Mount the motor attachment to the slider rail as
shown in the picture below. You need an appro-
priate Allen Key tool.
Tilt axis assembly
Use one of the Nic-O-Tilt motor units and mount
it to the slider as shown in the picture below.
Turntable assembly
Use one of the Nic-O-Tilt motor units and mount
the turntable disk to it as shown below. The ad-
ditional arca rail that is included with the Nic-O-
Tilt is not needed if the bundle is used for the 3D
scan application.
Camera assembly
Mount your camera to the additional arca L-bra-
cket and mount everything to the tilt axis as
shown below. Connect an appropriate camera
release cable to your camera and the camera 1
port of the PINE Controller (both camera ports
on the controller can be used).
Black Forest Motion