Advertisement
Advertisement
Table of Contents
Summary of Contents for 7-BIT Wicher 500i
- Page 1 Wicher 500i rev.2c Installation Guide...
- Page 2 Every action regarding your Amiga’s case disassembly should be performed with the computer being powered down. Before installing Wicher 500i rev.2c card one should remove Amiga’s case and dismantle the RF shielding. Next you should locate the U1 chip (MC68000 CPU) and remove it from its socket. This operation should be performed using a proper tooling.
- Page 3 Installing CPU in your Wicher 500i rev.2c card Wicher 500i rev.2c card supports the following processor models: MC68000, MC68HC000, MC68010 CPUs in PLCC68 packaging. The CPU should be installed in the socket located on the card in the position indicated in the following picture.
- Page 4 Wicher 500i rev.2c turbo card has been designed for installation inside the Amiga A500/A500+ computer. After removing the original MC68000 CPU, one can start the proper Wicher 500i rev.2c turbo card installation. In order to carry it out, the pins found at the bottom side of the turbo card, should be carefully inserted into the U1 chip socket and then the card should be pressed gently until it seats firmly.
- Page 5 Please take special care when installing the PCB board and connecting the signal cables. Incorrect installation may result in the damage to the computer or the turbo card. When Wicher 500i rev.2c card is properly installed, you can finally put it through its paces. X2 jumper configuration Position 0 –...
- Page 6 Software installation Please visit our website https://retro.7-bit.pland download software installer providing the necessary software components. More information about Wicher 500i rev.2c turbo card can be found on our website, at the following URL: http://retro.7-bit.pl 7-BIT Artur Gadawski ul. Miłostowska 23/7 Wrocław, Poland...
Need help?
Do you have a question about the Wicher 500i and is the answer not in the manual?
Questions and answers