Advertisement
Installation Instructions
Figure 6: Align the top and bottom pieces and screw into place
Figure 7: Push on the tunnel sides
Figure 8: Screw together your door mount
For replacement flaps and parts or other quality
pet products, visit
petprosupplyco.com
Continued
9
. Remove the screws in the four corners of the flap frame assembly as
shown in Figure 5.
10
. Place the top piece on, with the bent tabs down and align the top
piece so the holes in the tabs lines up with the screw holes in the
flap frame and screw in as shown in Figure 6. Repeat for the
bottom piece.
11
. Slide in the tunnel side pieces as shown in Figure 7.
12
. Bend the tabs down with your thumb or a screwdriver handle.
13
. Place the flap frame with the tunnel attached on the inside and
the other flap frame outside.
14
. Select the 2-1/4 inch set of screws for 1-3/4 inch doors and
the shorter set for 1-3/8 inch doors. Insert these into the pet
door from the inside. For doors with a thickness of less than
1-3/8 inch, see special instructions. For doors between
1-3/4 inch and 2-1/4 inch with the double flap door mount,
use the 2-3/4 inch screws.
15
. Start all four screws as shown in Figure 8, but do not tighten.
16
. Before tightening down the screws, check that the pet door is
level and adjust as needed.
17
. Tighten the screws until the weather-stripping compresses and
the pet door touches the door. Do not over tighten.
18
. Hammer the hole covers into the frame using the wooden end of
a hammer (or similar non metal tool).
19
. For double flap door mounts, apply silicone along the inside of
the tunnel where it mates with the flap frames to seal your pet
door from the elements. Failure to seal your pet door can lead to
severe water damage.
Advertisement
