Ideal Pet Products E-Cat Door Installation Instructions

Electronic

Advertisement

Quick Links

INSTALLATION INSTRUCTIONS
• Hammer and Awl (or Nail) • Drill and
• Sabre Saw • Phillips Screwdriver • Wear Safety Goggles
1. DETERMINE TEMPLATE PLACEMENT - The die-cut template is located in the
center of pet door. Remove beauty ring from outer frame; lift out template. Center
template (width) in middle of door; tape in place. Position the top of the template
approximately 2" taller than your pet's shoulder.
Important: Under no circumstances should the bottom edge of the template
cutout be less than 4" from the bottom edge of the wood door.
2. OUTLINE PET DOOR
OPENING - With template taped
in place, use a pencil to draw
around the inside edge of the
template onto door. Use a nail or
awl to mark outer screw holes.
3. DRILLING HOLES - Next: Drill
3
the four (4)
/
screw holes.
4. CUTTING THE OPENING - Mark
and drill four (4)
inside corner saw-out starter holes.
Begin with one of the inside
corner holes. Using a sabre saw,
cut along inside edge pencil line.

5. ASSEMBLY AND ADJUSTMENTS

(SEE DIAGRAM) - Insert outer
frame (A) into opening from exterior side (frame must be flush with door surface).
Place inner beauty ring (B) into opening from inside door and hold in place. Install
screws (C) and tighten until snug. Do not over-tighten.
6. ADJUSTABLE FLAP OPERATION - Using the red dial (D) located on door's lower
side, adjust to match desired operation as indicated by embossed symbols on door.
LOCKED.
Both In or Out
All parts are guaranteed to be free of manufacturers defects in workmanship and materials, excluding flap or breakage
of the glass panels. Lifetime warranty applies to the original purchaser only with proof of sales receipt.
All defective parts will be replaced free of charge. The replacement part will be sent when we receive proof of purchase
and a check in the amount of $10.00 to cover shipping and handling, Payable to: IDEAL PET PRODUCTS, INC.
This warranty is void if damage to material is due to improper installation or intentional abuse.
IDEAL Pet Products, Inc., 24735 Avenue Rockefeller, Valencia, CA 91355
As with any home improvement project, if you do not have the tools or skills to properly install your pet door,
© 2003 Ideal Pet Products, Inc
"Electronic" E-Cat Door

TOOLS REQUIRED FOR INSTALLATION

" diameter outer
8
3
/
" diameter
8
3
/
"
8
Limited Lifetime Warranty
Attn: Pet Products Warranty Dept.
we suggest using a professional handyman or licensed contractor.
(A)
(D)
#3-
Drill Outer
Screw Holes
Installation Diagram
UNLOCKED.
Active
1
3
/
" Drill Bit
8
Cut
Out
(C)
(D) detail
UNLOCKED.
Free In or Out (Open)
Part# 909 1030 Rev. 11-08
(B)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the E-Cat Door and is the answer not in the manual?

Questions and answers

Summary of Contents for Ideal Pet Products E-Cat Door

  • Page 1 All defective parts will be replaced free of charge. The replacement part will be sent when we receive proof of purchase and a check in the amount of $10.00 to cover shipping and handling, Payable to: IDEAL PET PRODUCTS, INC.
  • Page 2 “Electronic” Pet Door Training- In case your animal has never used a pet door before you may need to use a gentle approach to training him to become comfortable with the idea. Especially in the case of a mechanically activated pet door, an adjustment period will be necessary for the first 4-5 days.

Table of Contents