1. Straighten and assemble all
bungeed poles.
4. Lay frames down. Pull pillowcased
graphic over frame and zip closed.
7a. Attach feet to bottom of frames.
Secure foot with locking pin.
General Assembly Instructions
Note: Assembly is the same for all shapes and sizes of Elements Frames
2. Connect poles to corners.
(See diagram to on next page)
5. Clamp optional lights on top bar.
Tip: Put lights on before standing the display up.
DL
7b. If your kit includes a double foot
labeled (DL), connect as seen above.
Frame on right (shown in gree
above) attaches to the front foot
nub and overlaps the back frame by
approximately 3.5 inches.
Companion II Display
3. If your kit includes a center
support pole, insert it into the
corresponding holes, located in the
top and bottom poles of the frame.
Frames over 100" wide recquire support poles
7c. If your kit includes a double foot
labeled (DR), connect as seen above.
Frame on left (shown in green
above) attaches to the front foot
nub and overlaps the back frame by
approximately 3.5 inches.
6. Stand frames up.
Note: This step is easier with two people.
DR
Updated 10/16/2014