Se-Kure Controls Vantage II SK-584P Installation Instructions

Installation Instructions for the
SK-584P Vantage
w/Angled Sensor & Power Connection for T-Series + Power Alarms
SKD-584P
Vantage II Stand w/Angled
Sensor & Power
1.
Remove the Security Screws
at the base of the Vantage II
Stand with the SK-11-309 Handle
Driver & SKP-190 Driver Bit or the
SKP-190T Security Wrench.
Se-Kure Controls,
3714 Runge Street • Franklin Park, IL 60131 • 1-(800) 322-2435 • (847) 288-1111 • Fax: (847) 288-9999
Rev. 11/12/09
Optional Parts & Accessories
SK-122-PWR-25
2' Connecting Power Cable
Follow the Battery
and Installation
Instructions that
come with your
Alarm Module.
SK-T12P
T-12 Alarm Module w/Power
ASSEMBLY INSTRUCTIONS:
2.
Remove the Base Plate
from the bottom of the
Vantage II Stand and place it
over the hole on the display.
©2009 Se-Kure Controls,
II
Stand
SKP-190T
Security Wrench
To find the Adapter for
your device, contact your
Se-Kure Controls
Customer Service
Representative.
SK-PS-126-S (shown)
Power Adapter
Provides Power to the T-Series
Alarm & 5v to Connected
Devices
SK-295P
12 Volt Power Supply
3.
Mount the Base Plate to
the display (Use the appro-
priate fasteners for your dis-
play surface).
® Inc.
® Inc.
SK-11-309
Driver Bit Handle
Fits Driver Above
SKP-190
Security Screw Driver Bit
SK-585
Angled Sensor Adhesive
4.
Plug the SK-122-PWR-25
Alarm cable into the phone
jack in the base of the
Vantage II Stand.
On the Web: www.se-kure.com
E-Mail: info@se-kure.com
SCI-9936