Installation; Operation - Cecilware CTR2.68LD Operator's Manual

Installation

NOTICE: For most efficient operation, install the unit
in a place which is well ventilated.
Please read this manual before installing the
refrigerator.
1. Carefully remove package, tape, and other
shipping materials and leave door open to
ventilate.
2. Level unit by adjusting the feet.
3. The unit is cleaned before shipment.
However, clean the compartment interior
once after delivery.
4. Insert plug into a dedicated wall outlet. Do
not use an extension cord.
5. Allow the unit to operate about 1 hour to
cool the compartment before placing items
in the refrigerator.
If you need help, call Grindmaster Cecilware Technical
Service Department for help, (502) 425-4776 or (800)
695-4500 (USA & Canada only) 8 AM - 6 PM EST.
Prior authorization must be obtained from GMCW for
all warranty claims.

Operation

Your new refrigerator is easy to operate and maintain.
Before you place it in service, please have all personnel
familiarize themselves with these instructions. Keep
this manual in a convenient place for ready reference.
Temperature Adjustment
The temperature can be adjusted between
approximately 34° F and 45° F.
1. Adjust the storage temperature through the
temperature controller.
2. The temperature adjustable capacity is from
"1"-"5". Adjust the storage temperature by
turning the temperature
clockwise. The "5" setting is for colder
storage temperature. The knob can turn
4
freely but can't turn clockwise from "5"
to"1". Factory setting position is on "3"
position.
3. Check if the knob is on the appropriate
position
adjustments are not necessary.
4. To turn unit off, turn dial to position "0".
Notice: After the unit is turned off, wait 30
minutes
immediately after it has been turned off
may cause fuses to blow and activate the
circuit breaker; the compressor may be
overloaded, and/or other damge may occur.
5. Excessive refrigeration will cause increased,
unnecessary electricity consumption.
Shelf Height Adjustment
The shelf height can be adjusted. Arrange the shelves
in accordance with the dimensions of the items to be
placed in the cooler.
Helpful Hints
To prevent cold air from escaping, open and close the
door quickly.
Power Failure
In case of power failure, keep opening and closing of
door to minimum and avoid placing new items in the
refrigerator as this will raise the temperature inside the
compartment.
Moving the unit
• Keep the unit vertical when carrying the unit. The
angle to the horizontal line should not be over 50°,
otherwise it will damage the compressor and affect
normal operation of the unit.
• Use care not to damage feet.
• Do not allow feet to damge power cord. Inspect
cord before plugging into outlet.
• Level the unit using adjustment on the feet.
• After moving the unit, let it stand for 30 minutes
before switching it on.
• If the unit was previously running: Close the door
and connect the power. Turn on the light switch.
The temperature should be suitable for normal use
after half hour.
• If the unit was not previously running: After
connecting the power, the unit should be kept
controller
empty for one hour.
Cecilware
®
before using. Frequent
before restarting. Restarting
Countertop Refrigerators