Advertisement
If the customer happens to buy two sets, please refer to the below graphics to connect and disconnect the ramps.
Picture 1: connect two ramps.
Similar and refer to the IM of AD16469,
ISSUE
Vehicle does not work, red LED on transmitter is
flashing SLOWLY.
Vehicle does not work, red LED on transmitter is ON, red
LED on vehicle flashes SLOWLY
Vehicle runs by itself after vehicle and transmitter are
turned ON.
Trouble Shooting
CAUSE
Battery in transmitter is low.
Rechargeable battery is LOW.
Trigger of transmitter is not in the
correct position.
Picture 2: Disconnect the ramps.
CORRECTION
Replace batteries with new 4x 1.5V AA batteries. (Alkaline batteries are
recommended)
Re-charge the vehicle by following charging instruction on page 1. Make sure USB
charging cable is well connected to
charging port on the vehicle.
Note: RED light in USB will turn ON while charging. RED light will turn OFF to indicate
charge is complete.
Turn vehicle and transmitter OFF. Next, turn steering wheel of transmitter clockwise
and turn transmitter ON at same time.
Note: Do not touch trigger of transmitter during this step.
Then turn vehicle on.
Advertisement
