Advertisement
REPLACING THE BATTERY
FOR WARRANTY INFORMATION AND FOR DETAILS REGARDING THE LIMITATIONS OF THE
ENTIRE ALARM SYSTEM, REFER TO THE INSTALLATION INSTRUCTIONS FOR THE
RECEIVER/CONTROL WITH WHICH THIS DEVICE IS USED.
THIS DEVICE COMPLIES WITH PART 15 OF FCC RULES. OPERATION IS SUBJECT TO THE FOLLOWING
TWO CONDITIONS: (1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND (2) THIS DEVICE
MUST ACCEPT ANY INTERFERENCE RECEIVED, INCLUDING INTERFERENCE THAT MAY CAUSE
UNDESIRED OPERATION.
165 Eileen Way, Syosset, New York 11791
Copyright © 1999 PITTWAY CORPORATION
2
1.
Remove case back by using the blade of
a small screwdriver to pry it open.
2.
Remove old battery
3.
Place batter in case back locations (see
diagram above). - NEGATIVE END
MUST FACE DOWN.
4.
To close, snap case front and back
together.
Important Note: Do not remove Printed
Circuit Board.
SPECIFICATIONS
Unit Dimensions:
55mm x 37mm x 12.7mm
Battery:
Maxell CR2032, Duracell DL 2032, or Varta
CR2032
FCC ID: CFS8DL5805
Advertisement
