Advertisement
Extension tube
accessory for use
with Auray CFP-
series boom poles.
Manufactured with
sturdy, lightweight
carbon fiber for
portability and
reliability.
Integrated cable
with high-quality
TA3 (mini XLR)
connectors
manufactured by
Rean® (a registered
trademark of
Neutrik®).
www.AurayAudio.com
Auray is a registered trademark of the
Gradus Group. © 2016 Gradus Group LLC.
All Rights Reserved.
GG2
Adding an Extension – Boom Pole with
Side-Exit XLR
1.
Unscrew the side exit housing,
move the plastic strain relief cap so that
the TA3 connector inside the housing is
exposed.
2.
Disconnect the TA3 connector by pressing
on the locking tab and gently removing the
connector from the mount.
Note: The TA3 connector should easily
disconnect. Do not force or pull on the
cable to disconnect it. Doing so could
damage the housing or the connector.
3.
Use a small slotted screwdriver to reach
inside the strain relief and depress the
locking tab of the TA3 connector. With the
locking tab depressed, you can slide the
strain relief over the TA3 connector and off
of the cable.
Set the strain relief piece
3
aside.
4.
Connect the male TA3 connector of the
included cable to the female TA3 connector
of the coiled cable of the boom pole.
5.
Snake the included cable through the
extension tube.
6.
Screw the extension tube onto the end of
the boom pole.
7.
Fit the narrow side of the strain relief over
the TA3 connector, and push it past the
TA3 connector's locking tab.
8.
Plug the TA3 connector into the bottom
housing by inserting it into the TA3 mount
and pushing in until it clicks.
Note: When properly aligned, the TA3
connector will easily slide into place.
Do not try to force the connector into
the mount. Doing so could damage the
connector or the mount.
9.
Push the strain relief all the way into the
side exit housing so it sits over the TA3
connector.
5
10. Screw the side exit housing onto the end of
the boom pole.
and
1
1
2
2
3
4
4
5
CFP-ET Series
Carbon Fiber
Extension Tubes
for CFP-Series Boom Poles
Owner's Manual
Advertisement
Table of Contents
Summary of Contents for auray CFT-ET Series
- Page 1 TA3 www.AurayAudio.com connector. 10. Screw the side exit housing onto the end of Auray is a registered trademark of the Gradus Group. © 2016 Gradus Group LLC. the boom pole. All Rights Reserved.
- Page 2 Instructions Introduction Precautions Thank you for choosing Auray. Adding an Extension – Boom Pole with Bottom-Exit XLR The Auray CFP-ET-series • Please read and follow extension tubes are extensions for these instructions, and Unscrew the bottom housing from the base Auray’s CFP-series boom poles.
Need help?
Do you have a question about the CFT-ET Series and is the answer not in the manual?
Questions and answers