Advertisement
«
comes from previous page
2.
Press one of the macro buttons (M1 or M2), the green LED will start blinking.
3.
Setting up the COMBO: press the button combination that you wish to program with a maximum
of 15 buttons. In case you use the stick, keep in mind that it must go back to the central position
before moving it again to a new direction.
4.
After you finish setting up the combo press MACRO button to exit MACRO mode. Then the green
LED will turn off.
5.
A button can not be appointed with both TURBO and MACRO modes. Turbo will only work when
the macro function is cancelled.
6.
Only two buttons (M1, M2) can be set up with MACRO function. The button's original function will
be lost after appointing a macro to them.
7.
The buttons that could be used for the COMBO are: "A", "B", "X", "Y, "LB", "LT", "LS", "RB", "RT",
"RS", " ", " ", " ", " ".
Keep in mind: Although the stick would be set as analog, when recording macros its moves will be detected in D-Pad mode.
04
»
continues in next page
Kumite
User Manual
INDEX
Technical Specifications
Technical Specifications
Button's function table
Button's function table
Functions and modes
∆ Mode switch
∆ Mode switch
∆ TURBO set up & removal
∆ TURBO set up & removal
∆ MACRO set up
∆ MACRO removal
∆ MACRO removal
Installation
Installation
Advertisement
