Supersonic Gate and Door Automation MUC300 Installation Instructions

OPERATIONAL CHECK

To check operation, move back a reasonable distance (about 50 ft.) and press
the transmitter button. Operation should be reliable at this distance but
environment and location of both the transmitter and receiver will affect the range.
If the transmitter is stowed well out of sight, it may be necessary to remove it
from its mounting and hold near the windshield. Try different locations and
positions. If operation is still unsatisfactory, the problem may be isolated by:
1. Checking the door operator. If the door will not open when the wall button is
pressed, the problem is likely to be the operator. If the door will open by
pressing the wall button, but not when the radio control button is pressed, the
problem is probably in the radios.
2. Replacing the transmitter battery. If after performing the above operational
checks, the controls still do not function, they should be returned to your dealer
for repair or replacement.
SUPERSONIC GATE AND DOOR AUTOMATION CO.,LIMITED
INSTALLATION INSTRUCTIONS
DIGITAL TRANSMITTER MODEL MUC300
Congratulations! You have just purchased a MUC300 Digital Transmitter,
we believe to be the finest product of its kind on the market. With a little
transmitter should provide you with many years of excellent service. Please take
a moment to read the following instructions and you will find that setting your new
transmitter will be quite an easy matter.
between 300MHz and 310MHz by pressing the key(3s)

ACCESSING THE CODE SWITCH

Insert a small coin into the slot located at the bottom end of the transmitter. Twist
the coin and remove the access cover to expose the code switch and battery
compartment.
care this
The user can Switch the working frequency
which