Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Summary of Contents for Mincon Rockdrills MC60
- Page 1 • Toll Free: 888-883-5144 Mincon MC60...
-
Page 2: Table Of Contents
Checking Wear Limits ............................. 6 2.3.7 Reassembly ..............................6 TROUBLE SHOOTING ........................7 APPENDIX ............................8 DTH H ..............8 AMMER EXPLODED VIEW AND ARTS IST AND ECHNICAL ............................9 AMMER ERVICE WARRANTY ............................9 Mincon Rockdrills – “The Driller’s Choice” Page 2... -
Page 3: Introduction
Thank you for choosing the Mincon MC60 Down-the-Hole hammer. Please read this manual carefully before using your hammer in the interests of safety, warranty and best operational care. The Mincon MC60 is ruggedly built with a hardened wear sleeve to withstand the stresses of drilling in the most extreme conditions. -
Page 4: Operation
Mincon Rockdrills – “The Driller’s Choice” Page 4... -
Page 5: Opening Chuck And Backhead
In these cases, the piston should be replaced if there is evidence of such cracking. Check the strike face of the piston for cracking or damage. Mincon Rockdrills – “The Driller’s Choice” Page 5... -
Page 6: Checking Wear Limits
This gap should be between 0.015” and 0.030”, and can be measured using a feeler gauge. If the gap is less than the minimum, then the lock ring will need to be replaced. Protect the hammer as earlier described by internal lubrication. Mincon Rockdrills – “The Driller’s Choice” Page 6... -
Page 7: Trouble Shooting
Contamination from excess water Avoid excessive water. Use only pH neutral water. Use only filtered injection causes pitting in the piston water, free from contamination face and external failure Mincon Rockdrills – “The Driller’s Choice” Page 7... -
Page 8: Appendix
• Toll Free: 888-883-5144 4. Appendix 4.1 DTH Hammer exploded view and Parts List and Technical Data MINCON MC60 PARTS LIST AND SPECIFICATIONS Item Description Part Number Mincon MC60 Hammer MD601AS08 Backhead MD601BH01 O Ring MD623OR01 Choke Blank MB506CH01 Choke 1/8”... -
Page 9: Hammer Service Log
Note 1: If no evidence of significant air pressure drop or if wearsleeve is wearing evenly on the top and bottom end, recommendation is to not reverse wearsleeve. Note 2: Chuck should be replaced when wear transfers to wearsleeve. Mincon Rockdrills – “The Driller’s Choice” Page 9... -
Page 10: Warranty
There is damage caused as a result of using incorrect servicing tools or procedures. • If it is evident that the hammer or its components have achieved a reasonable proportion of their anticipated life. Mincon Rockdrills – “The Driller’s Choice” Page 10...
Need help?
Do you have a question about the MC60 and is the answer not in the manual?
Questions and answers