Troubleshooting - Breezer Oasys AB10-A-OO-G User Manual

Troubleshooting

Before contacting the Customer Care Center, please locate your
Breezer Oasys' serial number inside the reservoir and have it ready.
Atomizing disk is spinning,
but there is no mist:
1. Verify that there is water in the
reservoir.
2. Verify that the water pump is
running. Water pump should
vibrate when running.
3. If water pump is running but there
is no water flowing, check that the
water valve output is open and
that the water valve output is
open enough for your climate
(See page 9).
4. Clean water pump. See cleaning
the water pump (Page 11).
5. If the above steps fail, the water
pump may need to be replaced.
Please contact our customer
care center at:
customerservice@breezercooling.com
or 844-233-5673.
Your Breezer Oasys shuts off:
1. Unplug your Breezer Oasys.
2. Wait 10 seconds, then plug it
back in.
3. Restart your Breezer Oasys.
Your Breezer Oasys will not roll
when pushed:
1. Ensure wheel brakes are in the
OFF position.
Misting output is too high and
droplets are creating excessive
moisture:
1. Reduce mist output setting.
See adjusting your Breezer Oasys
for your environment (Page 9).
Unit is plugged in, and powered on,
but the LED lights are off:
1. The LED lights dimming feature
may have been activated. The LED
lights may have to be brightened
(See Page 10).
ENGLISH
13