Table of Contents
Advertisement
Page 36
Chapter 9. Powering Down the Cabinet
The RadioRouter BaseStation is powered down using a PC connected to the COM1 port on
the MCU board. The PC should be running a terminal emulation such as Microsoft Windows
HyperTerminal.
AFTER THE RADIOROUTER BASESTATION IS POWERED UP, IT CANNOT
BE POWERED DOWN WITHOUT THE USE OF A CRAFT ACCESS
TERMINAL. POWERING THE BASESTATION DOWN WITHOUT THE USE
OF A CRAFT ACCESS TERMINAL COULD PERMANENTLY DAMAGE
THE EQUIPMENT.
Procedure 9-1 Powering Down the Cabinet
1.
Connect a PC to the serial port of the MCU.
2.
Run a terminal emulator such as Microsoft Window HyperTerminal.
At the Login: prompt, type root and press Enter.
3.
At the Password: prompt, type the root login password and press Enter.
4.
5.
At the BS_Name#> prompt, type halt and press Enter. Be careful not to touch any other
keys after hitting Enter or the system will restart.
6.
The system will display the message System Halted followed by the message
Press any key to reboot. Do not press any keys.
Turn off the PA breakers. The PA breakers are on the right as you face the cabinet. See
7.
Figure 8.2 Circuit Breakers — Front View
Turn off the LNA breakers which are located to the left of the PA breakers.
8.
Turn off the RRC breaker. The RRC breaker is on the left as you face the cabinet next to
9.
the LNA breakers.
Page 36
WARNING:
®
RadioRouter
BaseStation Installation Guide — Draft
Version 0.5 - © 2003
Advertisement
Table of Contents
