Advertisement

QUICK START GUIDE
1. Uncrate the console and inspect for any damages.

2. Console Installation,

a. A Phillips screwdriver is required for the install.
b. Position the tablet stand with one of the two sets of pre-drilled holes.
c. The console supports mounting the computer in the center or on the left side of the top.
d. Use the 4 wood screws enclosed to fasten the stand to the desk.
e. Clamp the tablet into place and fasten cables.
3. Plug console into electrical outlet that has clean power.
CAUTION: A power source with abnormal voltage or excessive noise can result in improper console operation and
possible damage not covered under warranty. Ensure electrical outlet is not on an air-conditioning, heater, fridge or
range circuit.
© ARROW INTERNATIONAL INC.
Center computer mounting holes.
Left side computer mounting holes.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Envoy and is the answer not in the manual?

Questions and answers

Summary of Contents for Arrow Envoy

  • Page 1 © ARROW INTERNATIONAL INC. QUICK START GUIDE 1. Uncrate the console and inspect for any damages. 2. Console Installation, a. A Phillips screwdriver is required for the install. b. Position the tablet stand with one of the two sets of pre-drilled holes.
  • Page 2 QUICK START GUIDE 4. Turn on the main power switch on the console. The switch is located on the top left side of the unit. Hold the button for 2 seconds and wait for a while, tablets take a bit longer to boot up. NOTE: This switch must be turned on first before the tablet is turned on.
  • Page 3 QUICK START GUIDE 7. The Envoy has been set up with sample schedule so you can press Play Bingo and begin the session. 8. Now turn the Blower Motor to High to begin play. 9. Deactivate will end a currently active Schedule. If there is no current Schedule, it will be grayed out.
  • Page 4 WARNING: A proper shutdown of the gaming computer is required. Close your Schedule. Press EXIT. It will ask if you are sure you want to shut down, press YES. Arrow Technical Assistance Center Phone Support Hours: 8am to 12am 1-800-277-6214 ©...

Table of Contents