Page 1
TN-C215 SERVICE MANUAL CORDLESS TELEPHONE This Service Manual is the "Revision Publishing" and replaces "Simple Manual" (S/M Code No. 09-99B-336-4T1). This Service Manual does not include "ADJUSTMENT" These items will be issued in the next Supplement. S/M Code No. 09-99B-336-4R1...
Page 9
SCHEMATIC DIAGRAM-2 (HS-RF 1/3) COL0 SELECTION TX DATA COL1 CHARGE DET COL2 RX DATA COL3 LB LED TALK LED XTOUT PC13 ZPC7 XTIN KEY LED FN COL BATT ALARM VOL HI N.C. VOL LO SIG OUT EEPROM RX PWR BUZZER TEST ROW3 RESET...
Page 13
IC DESCRIPTION IC, TMP87C408N Pin No. Pin Name Description XOUT Oscillator out Oscillator in TEST Tied low Hook control output (for corded phone): 0 = OFF HOOK, 1 = ON HOOK HOOK CONT For ZPC-6: this pin is used as Speaker Amp, IC Mute Control) SPK MUTE (the Mic Mute control is controlled by hardware: unmute mic when Speaker is unmute and charge not detected)
Page 14
IC, TB31224F Pin No. Pin Name Description TX-IN Input terminal of TX VCO oscillation signal. VCC3 — Power supply terminal. LOCAL OSCILLATOR input and output terminals. Colpitts oscillator is formed by 3, 4 LO-1, LO-2 internal emitter follower and external X’tal. And external injection is possible from pin SIG OUT Output terminal of detection signal.
Page 15
Pin No. Pin Name Description After output of NOISE FILTER amplified around 20dB, noise signal is rectified by N-REC external capacitor. 2ND MIX-IN 1st IF signal input terminal. Input impedance is around 4.7kΩ at 10.695MHz. E-RECT Connected capacitor for full-wave rectifier circuit of EXPANDER. 1ST MIX-OUT MIX output terminals.
Page 16
IC, TMP87C807U Pin No. Pin Name Description SQ SELECTION OUT OF RANGE FUNCTION: 1 = YES, 0 = NO TX DATA Transmitted data CHARGE DET Charge detect: 1 = charging, 0 = not charging RX DATA Received data (INT3/TC3) LB LED Low battery led (High current port): 1 = ON TALK LED Talk led (High current port): 0 = ON...