BAPI VC3000 series Installation And Operation Instructions

9532_ins_ps_vc
Termination
VC 3000 Voltage Converter
The VC3000 series voltage converter is powered with 24 VAC. Wire as shown in Fig. 1 below. When properly wired,
the red Power Output LED will light.
24VAC
Half Wave
Neutral
24VAC
Full Wave
Neutral
24VAC Hot
NOTE: The selection of the
"Hot" and "Neutral" wires
for the 24VAC input is very
important.
Clip Settings
Rectification Settings
The AC to DC rectification may be set to
either full wave or half wave by attaching
the supplied clip to terminal block J2.
Attach the clip to J2 for full wave. Do not
use the clip for half wave. Note: If the
VC3000 is ordered FW the clip is installed
on J2. If the VC3000 is ordered HW, the
clip is taped to the bottom of the metal
plate.
When multiple devices (such as
controllers, actuators, and the VC3000)
are connected to one transformer, the full
wave/half wave rectification of all devices
must match. For example, if the controllers
being used are half wave and connected
to the same transformer that supplies the
voltage converter board, then do not use
the clip on J2. Always remove 24 VAC
power before changing the clip position.
Building Automation Products, Inc., 750 North Royal Avenue, Gays Mills, WI 54631 USA
Tel:+1-608-735-4800 • Fax+1-608-735-4804 • E-mail:sales@bapihvac.com • Web:www.bapihvac.com
Output Adjust Trim Potentiometer
Factory Set at 24 VDC
Clip
Attach Clip to
the Terminal
Block J2 for
Full Wave
Rectification
Specifications subject to change without notice.
Voltage Converters
Installation and Operation Instructions
Note: The voltage converter output is set
at the factory, but can be adjusted in the
field. Please refer to the "Voltage Output
Adjustment" instructions on page 2 of
this document.
Fig. 2: Attach Clip for Full Wave Rectification
rev. 01/23/13
Output Terminal Block
1.2 to 24 VDC Output
Red Power Output LED
Fig. 1: VC3000