RACOR PSM-1R Instructions

H O M E S T O R A G E P R O D U C T S
TOOLS REQUIRED
Phillips driver
1/8" Drill bit
Drill
WARNING
Please read installation instructions carefully prior to installing. Before using the product thoroughly test the fully-weighted
product (with equipment in place) to ensure the product has been installed properly. Do not allow children to play on
product. ITW Brands is not responsible for any damage resulting from improper installation, overloading or product failure.
1
Verify the height of the hook is at a
convenient location and that the
wheelbarrow or ladder has adequate
clearance once hanging.
PARTS LIST
x1 Bracket
Clearance
WHEELBARROW AND
LADDER HANGER | PSM-1R
INSTRUCTIONS
WWW.RACORSTORAGESOLUTIONS.COM
x2 2'' (5 cm) wood screws
MARK
2
Position the bracket on the wall with enough
ceiling and floor clearance for the wheelbarrow
or ladder. Make sure the rack is level.
Mark holes through rack mounting plate, drill
1/8" pilot holes and install screws into stud.
Tighten screws firmly.