Page 1 INTRODUCTION Thank you for purchasing the Belkin Floppy Drive Kit. The Kit provides a quick and easy way to add a floppy disk drive to your computer. The floppy drive installs directly into any available 3.5-inch drive bay on your computer.
P74065-F5U099-man_6-02.qxd 6/24/02 5:06 PM Page 2 FEATURES • 3.5-inch form factor • 5.25-inch drive bay adapter • Standard Microsoft ® Internet Explorer user interface • Draws power from computer’s internal switching power supply • Support for DOS and Windows ®...
P74065-F5U099-man_6-02.qxd 6/24/02 5:06 PM Page 3 SYSTEM REQUIREMENTS Make sure your computer is IBM ® PC-compatible with the following minimum system requirements: • 486DX4 -100MHz CPU or higher • One available FDD controller (check your computer system manual for location of the FDD controller) •...
You will use the same cables to connect your new Belkin floppy drive. 4. Refer to your computer system manual for instructions regarding the mounting of disk drives.
P74065-F5U099-man_6-02.qxd CONFIGURING THE FLOPPY DISK DRIVE Your floppy disk drive can be configured as either “drive A” or “drive B” depending on how the floppy interface cable is connected. 1. To configure as drive A, connect your floppy drive to connector (A).
P74065-F5U099-man_6-02.qxd 6/24/02 5:06 PM Page 6 TROUBLESHOOTING Drive activity LED does not light when attempting a read or write data. Make sure that the interface cable and power cables are properly connected. Drive activity LED lights as soon as power is applied to computer, and stays lit.
Belkin Components warrants this product against defects in materials and workmanship for its lifetime. If a defect is discovered, Belkin will, at its option, repair or replace the product at no charge provided it is returned during the warranty period, with transportation charges prepaid, to the authorized Belkin dealer from whom you purchased the product.