Mitsubishi Electric MR-L650EN series Operating Instructions Manual page 7

Bottom front of refrigerator
3
Adjustment and anchoring
(To prevent vibration, noise, movement, and ajar doors)
Turn the adjustable supports until they touch the floor and
the front casters are raised from the floor.
Preventing ajar doors
Adjust the supports to
make the refrigerator
level.
If the front of the
refrigerator is slightly
raised, the doors are
easier to close.
If the door is still tilted after adjustment of the supports
When installing the refrigerator in
the corner of a room, one of the
rear supports may sink, causing the
refrigerator to tilt. If this happens,
use a caster support or strong board
for adjustment. (Normally, use a
board with a thickness of about 2 to 3 mm.)
Prepare for earthquakes.
Thread 2 strong belts through the hand-holds on the top rear
of the refrigerator and anchor them to a strong location, such
as wall or post.
WARNING
The refrigerator may tip
over and cause injury.
Flat-blade
screwdriver
Adjustable
Caster
support
Adjusting a tilted door or unevenness
Readjust the adjustable supports as
shown in the figures below.
The ri g ht door ti l t s down The l e ft door ti l t s down
Right Left
Raise the right side Raise the left side
Strong belts
Insert the blade of the screwdriver
Turn the adjustable supports
in the arrow direction until
they touch the floor.
CAUTION
If the supports are not
adjusted properly, the
refrigerator may move
and cause injury.
If the installation
location is not level or
the supports sink after
a few days due to the
weight of the food,
the doors may appear
tilted.
Readjust the supports.
Rear support
Caster support
or strong board
Do not damage the refrigerant
circuit (pipes) or drive screws into it.
Although R600a refrigerants are combustible, the refrigerant
circuit is hermetically sealed and normally leaks will not occur.
WARNING
Should the refrigerant circuit be damaged:
1. Do not use flames or electrical appliances nearby.
2. Open the windows to fully ventilate the room.
Then, contact the retail store where you purchased the refrigerator.
Support cover
4
Support cover
The support cover is stored inside
the refrigerator compartment
at shipment.
Installing the support cover
While the freezer door is open
Insert the support cover horizontally
and fully, until it makes contact with
the rear side.
Adjustable
support
Support cover
The support covers are designed for the
left and right adjustable supports respectively.
The operation noise gets
louder immediately after
installation.
Immediately after instillation, when:
the weather is hot, the doors are
frequently opened or closed, or
any similar situation; the operation
noise will get louder because the
refrigerator will switch to high-speed
operation to cool with high power.
7